Dead Rail Installation Kits

Dead Rail Kits are designed for the person that wants to install their own Dead Rail System.  Kits Consist of the following.

Basic Kit-  Soldering required

Included in this kit:

  • Kit #1 $65.00
  • 11.1Volt 250ma Lithium Polymer Battery with Connector 
    • This is a high quality battery pack with protection control modules. (PCM)
    • PCM protects against low voltage, over charge, short circuits.
  • Shrink  Red & Black 3”
  • Kapton tape 4”
  • Charge Cable  1
  • Loco connector (s) 2
  • On/Off switch           1
  • Magnetic Reed Switch   1
  • 28AWG Silicone Wire Red & Black 6” each
  • On/Off wiring diagram
  • Instruction Sheet
  • Battery Dimensions are: In mm 31 X 21 X 18 tall. In inches 1.22 X .8 X .7 tall

  • Kit #2 $70.00
  • 11.1Volt 450ma Lithium Polymer Battery with Connector 
    • This is a high quality battery pack with protection control modules. (PCM)
    • PCM protects against low voltage, over charge, short circuits.
  • Shrink  Red & Black 3” each
  • Kapton tape 4”
  • Charge Cable  1
  • Loco connector (s) 2
  • On/Off switch           1
  • Magnetic Reed Switch   1
  • 28AWG Silicone wire Red & Black 6” each
  • On/Off wiring diagram
  • Instruction Sheet
  • Battery dimensions are: In mm 46 X 23 X 18 tall. In inches 1.81 X .95 X .71
  • Kit #3 $70.00
  • 11.1Volt 500ma Lithium Polymer Battery with Connector 
    • This is a high quality battery pack with protection control modules. (PCM)
    • PCM protects against low voltage, over charge, short circuits.
  • Shrink  Red & Black 3” each
  • Kapton tape 4”
  • Charge Cable  1
  • Loco connector (s) 2
  • On/Off switch           1
  • Magnetic Reed Switch   1
  • 28AWG Silicone wire Red & Black 6” each
  • On/Off wiring diagram
  • Instruction Sheet
  • Battery dimensions are: In mm 39 X 26 X 20. In inches 1.6 X 1.1 X .76
  • Kit #4 $70.00
  • 11.1Volt 850ma Lithium Polymer Battery with Connector 
    • This is a high quality battery pack with protection control modules. (PCM)
    • PCM protects against low voltage, over charge, short circuits.
  • Shrink  Red & Black 3” each
  • Kapton tape 4”
  • Charge Cable  1
  • Loco connector (s) 2
  • On/Off switch           1
  • Magnetic Reed Switch   1
  • 28AWG Silicone wire Red & Black 6” each
  • On/Off wiring diagram
  • Instruction Sheet
  • Battery dimensions are: In mm 39 X 26 X 20. In inches 1.6 X 1.1 X .76

  • Extra Banana Plug Charge Connector $8.00
  • Magnetic Wand. Soundtraxx IC Wand TUC810141 $7.95

Customer needs to supply:

  • Decoder
  • Radio Receiver
  • Battery Charger

Customer needs soldering skills to connect the parts.

Extra batteries are available. Individual components are not sold separately.